differ from original.
Highly effective pre-cleaner for surfaces of drinking water systems and for targeted biofilm removal in case of infestation by Legionella pneumophila and/or Pseudomonas aeruginosa in the piping system, drinking water system or water storage tanks and swimming pools.
Biofilm remover, basic cleaner, concentrate for all water reservoirs, swimming and bathing pools.
Specially developed biofilm solvent that reliably dissolves and removes acid-resistant algae and bacterial slime. The active ingredients contained specifically infiltrate the biofilm and effectively dissolve the harmful biofilm in the process. Only in this condition can a subsequent basic cleaning or disinfection measure be successful.
In addition to mineral coatings, which experience has shown to be reliably dissolved by acidic cleaners, algae and bacterial slime also occasionally occur in drinking water systems, swimming pools and bathing pools. Such mucilages consist of complex polymeric substances, which may include polysaccharides and peptides. These mucus coatings must first be removed with muEX forte so that deeper cleaning or disinfection can be successful.
– highly effective
– Dissolves and reliably removes algae and biofilms
– reinforces and secures the subsequent disinfection measure
A. Drinking water tank / surface cleaning:
muEX forte is applied liberally to the wet surfaces with a low-pressure sprayer. If necessary, rework with the UNIWISCHER. After 20-30 min exposure time, rinse off with a full stream of water. Before the actual cleaning or disinfection, flush the alluvial water into the tank sump.
B. Pipe network cleaning:
Pseudomonas aeruginosa and Legionella spec. mainly use slimy biomasses as their habitat, the biofilms, for reproduction or residence. These include the slime films on plant components in contact with water and the sediments that serve as protection for pathogenic Legionella and facultative pathogenic pseudomonads against conventional disinfectants. It is essential to remove these mucus films and sediments from the infected system. Disinfection is then only effective in the subsequent step. muEX forte is introduced into the pipe system by means of a suitable dosing device (e.g. PipeDes 60) in the biofilm-dependent 2-5% application concentration and fed through the entire house distribution network (cold and hot water). In the subsequent step, this solution remains in the pipeline system for at least 1.5 hours (standing time). After rinsing out the detached biomass with drinking water, a further cleaning step can be carried out or the disinfection step can be carried out directly with a 2 % application concentration (e.g. HYDRO-DES) and a standing time of at least one hour.
Container sizes depending on availability.
May be corrosive to metals.
Causes severe skin burns and eye damage.
Store only in original container.
Wear protective gloves/protective clothing/eye protection/face protection.
IF INTOXICATED: Rinse out mouth. DO NOT induce vomiting.
IF ON SKIN (or hair): Remove all contaminated clothing immediately. Wash off/shower skin with water.
IF IN EYES: Rinse cautiously with water for several minutes. Remove any existing contact lenses if possible. Continue rinsing.
IF EXPOSED or if affected: Call a POISON CENTER/physician immediately.
Keep out of the reach of children.
– Keep cleaning agents out of the reach of children.
– Do not store cleaning agents near beverage bottles because of the risk of confusion.
– Do not decant cleaning agents into beverage bottles under any circumstances. The cleaning agents could be mistaken for food and thus drunk.
For further information, please call our technical consultants at +49 7623 72240.
Product packaging may differ from the illustrations.